With the clip side of the piece facing you, put both thumbs on each side of the clip and the index fingers at the front side of the piece. Snap the clip open by applying pressure toward yourself with the index fingers. Similarly, close the clip by applying pressure away from yourself with the thumbs.

Using one of the 1.5" side pieces, practice attaching and removing the extension piece.

Using a tail comb or your index fingers, practice parting the hair where you wish to attach the first extension.

The clip-in extensions should be attached from the bottom up. Starting at the lowest point on the hairline, and using the tail comb or your index fingers, create a part where you wish to section off the hair.

Move the tail comb or your index fingers under the hair and along the scalp until the hair is separated from the right to the left hairline.

Lift up all the hair above the part and clip it out of the way.

Select one of the wider "back" wefts (if working with a complete kit, use the 6" width weft) and snap open all the clips.

The clips should be placed on your own hair below the part so that that top of the weft is even with the part.

The middle clip should be placed first by locating at the middle of the nape. Place the clip on your own hair just below the part. Moving the clip downward, catch your own hair in the clip and snap it shut.

The right clip is next. Holding the middle clip in place with your left hand, use your right hand to move the right edge of the weft as far as it will go around your head. As above, place the clip on your hair just below the part, and moving the clip downward, catch your hair in the clip and snap it shut.

Finally, to attach the left clip, hold the middle clip in place with your right hand, and use your left hand to move the left edge of the weft as far as it will go around your head. As in the previous two steps, place the clip on your hair just below the part, and moving the clip downward, catch you hair in the clip and snap it shut.

Now that all three clips are attached, run your fingers along the weft to make sure it lies flat against your head along the entire width. If there are any gaps, correct this by snapping the clip open, lifting it off your hair and repositioning it so that the weft lies flat.

This weft will be placed above the first weft. Release all the hair that was clipped out of the way in step six. Then, slightly above the weft that was just attached, make another part - as explained in steps 4 through 6.

Repeating steps 7-12, attach the next weft. To complete a style, follow steps 4-12 for each weft attached. (When working with a complete kit, start at the lowest point with the two 6" wefts, then attach the 7" weft, and finally the 8" weft.)

The four 1.5" wefts are meant to be attached to the sides of your head. Using two for each side, attach the forst one just above the ear and the second one around the temple area.

To remove a weft, snap open all the clips and gently lift up and away from your hair.

	Remember
Never try to remove a weft without first opening all the clips. Pulling or tugging to remove a weft can result in damage to your own hair.